|
drobom − CLI for managing drobo units |
|
drobom [ options ] <command> [ arguments... ] |
|
options is one of: |
|
−c, −−command |
|
the command to execute. |
|
−d, −−device |
|
the device to operate on (default searches all devices and picks first one found.) |
|
−h, −−help |
|
print a usage message |
|
−v, −−verbose |
|
verbosity, a bit-field to trigger increased output as needed, mostly for debugging. 1 - General, 2 - Hardware Dialog, 4 - Initiation, 8 - DMP layer, 16- Detection 64 will print everything... (default: 0, as terse as possible.) 128 enables simulation mode (for testing when no Drobo is available. Dangerous!) |
|
−V, −−version |
|
print the version id. |
|
command is one of: |
|
blink |
identify the drobo by making the lights blink |
|||
|
diag |
dump diagnostics file into /tmp directory |
|
diagprint <diagdumpfile> |
|
print diagnostics file to standard output <diagdumpfile> the diagnostic dump file to print. |
|
fwcheck query drobo.com for updates to firmware for the given Drobo |
|
fwload load a specific firmware for the given Drobo. Arguments: <fwimage> the firmware file to load. |
|
fwupgrade |
|
upgrade the firmware to the latest and greatest, recommended by DRI |
|
help |
print this text |
|
info <toprint> |
|
print information on a Drobo. The <toprint> argument is a comma separated list of the values below (default is to print all of them): config, capacity, protocol, settings, slots, firmware, status, options, luns |
|
list |
show device files for all Drobos found. |
|
name <newname> |
|
Set the name of the Drobo to the given value ( only firmware > 1.3.0 supports this command ) |
|
settime sync Drobo’s clock to UTC |
|
setlunsize Set the size of LUNS on device. Arguments: |
|
<sz> integer number of TiB to set the lunsize to <confirmation> Specify ’PleaseEraseMyData’ if you really mean it Note: After execution, Drobo reboots, wait a few minutes before accessing again |
|
shutdown |
|
shutdown drobo (DRI calls this ’standby’) |
|
status |
report how is the Drobo doing |
|
device |
|
raw block device of a drobo (i.e. /dev/sdz) . If not given, assumes all attached drobos. |
|
This manual page was written by Chris AtLee <chris@atlee.ca> for the Debian project (but may be used by others). |